Applied Software serves as one of the few Autodesk Advanced MEP Specialized Resellers with the ability to configure Fabrication CAMduct to your NC equipment. We have multiple techs trained to ensure this valuable software will drive your plasma tables and decoilers with optimal productivity.
But what sets us apart is our unique ability to configure your equipment remotely.
Until now, machine configuration for Fabrication CAMduct required an expert on site. Through our commitment to the fabrication industry, Applied Software developed specialized remote access technologies eliminating the need for travel.
Combined with our time-tested Success Assurance Methodology (SAM), remote configuration with Applied Software is a streamlined solution that has you up and running faster and at a lower cost.
This unique service is only available from Applied Software.
Here's how it works:
Simply provide us with information about your software, controller, and equipment and Applied Software will research the required communication protocols as well as verify the post-processor (device driver). This will take anywhere from an hour to several days depending on your specific setup. In the event your equipment requires a new post processor, Applied Software will coordinate with Autodesk to create a new one.
From here, we connect your Fabrication CAMduct computer to our remote screen sharing technology and configure your system while you watch. Using a photo of your table and controller, we will direct you to enter certain commands to complete the process. Through remote communication with our trained tech, configuration is simple and efficient.
Once configuration is complete, we will send you a test file to confirm that your machine is operating correctly. Email us a copy of the backup for offside storage and if you ever have a problem, we can easily restore your configuration.
Only Applied Software takes machine configuration for Fabrication CAMduct to the next level. Are you ready to go remote? Give us a call today.